From 1 - 10 / 170
  • <p>Geoscience Australia conducted the Bowen Basin Seismic Survey during July to October 1989. The major aim of the seismic survey was to record deep seismic reflection data across the northern part of the Bowen Basin, to test geological (extensional) models for the formation of the Bowen Basin. The deep seismic reflection survey by the BMR recorded 254 km of eight-fold Common-Depth-Point (CDP) seismic data, along three seismic lines.<p><b>Raw data for this survey are available on request from clientservices@ga.gov.au - Quote eCat# 74954</b>

  • <p>Geoscience Australia conducted equipment tests at Millmerran, Queensland, using the newly acquired Sercel SN368 data acquisition seismic system. The equipment operated satisfactorily and proved to be versatile.<p><b>Raw data for this survey are available on request from clientservices@ga.gov.au - Quote eCat# 74967</b>

  • Seismic reflection survey has been conducted to help identify the possible oil-bearing structures, which were revealed by two residual gravity anomalies in a geophysical survey made by the Bureau of Mineral Resources. Good reflections were obtained in some parts of the area, but the quality was not consistent. The seismic results appear to confirm a small closure near one of the gravity anomalies. No definite closure is shown near the other anomaly.

  • The Bureau of Mineral Resources made an experimental seismic survey in the Otway Basin, Victoria and SA, and in the Sydney Basin, NSW, from April to November 1965 and from mid February to mid March 1966. The survey used explosives as an energy source to obtain seismic reflection data for comparison with the results from an experimental 'Vibroseis' survey carried out for the Bureau by Seismograph Service Ltd during 1964.

  • On 30th March 1960, a seismic velocity survey was made in the A.A.O. Timbury Hills No. 2 bore, jointly by the Bureau of Mineral Resources and Associated Australian Oilfields N.L. The bore had been drilled to a depth of 4400 ft and was surveyed to a depth of 4304 ft below the rotary table. There remains a doubt whether the breaks recorded on the well geephone were, in fact, cable breaks, particularly between 2300 and 3305 ft below the rotary table. The interpretation has boon made with the belief that true breaks wore recorded. Average and interval velocities were computed and are acceptable geologically. Sandstones, particularly cemented ones, have Renerally higher velocities than shale. The average velocity of the Mesozoic sequence is about 9800 ft/sec. A velocity of 17,980 ft/sec was measured at the bottom of the bore and corresponds to the Timbury Hills Formation of unknown age. The Moolayember Shale has a low velocity calculated as 8360 ft/sec.

  • A seismic velocity survey of the APM Development Pty Limited No. 1 bore at Rosedale, Victoria, was made by the Geophysical Branch of the Bureau on the 3rd May 1960 using a TIC three-component well geophone. Measurements were taken with the geophone suspended in the well at selected intervals down to 5500 ft. It was apparent that signals reached the geophone by transmission along the cable by which it was suspended, and these interfered with the signals reaching the geophone along a path directly through the ground. This made interpretation difficult; however, by careful inspection of both the vertical and horizontal components of the signals received by the geophone at each depth, an interpretation has been made that yields a series of velocity/depth determinations. The average vertical velocity increases from 5000 ft/sec at the surface to 8930 ft/sec at a depth of 5500 ft. The average velocity in the Tertiary (0-2159 ft below datum) was computed to be 6420 ft/sec; the -werage velocity in the Mesozoic rocks penetrated (2159-5314 ft below datum) was 12,180 ft/sec. Two reflection spreads laid out and recorded in the vicinity of the bore showed the presence of reflectors at depths estimated to be in excess of 7700ft.

  • Towa.:ccis the end of 1960 , the Bureau. of Mineral Resources, Geology and Geophysics made a brief seismic survey in the Winton area of Queensland to resolve an apparent contradiction between the interpretations of gravity and aeromagnetic results previously obtained in the area. Gravity and aeromagnetic results both suggested the occurrence of a large fault or fault zone about 20 miles north-west of Winton, but the gravity and aeromagnetic interpretations differed regarding the direction of throw of the fault. A nine-mile seismic reflection traverse was surveyed across the supposed fault. The seismic results indicate the presence of a large fault or monoclinal fold with dowthrown side nouth-wast as suggested by the gravity values and also a smaller fault or monocline about two miles south-east with downthrown side south-east. The variations in thckness of Mesozoic rocks caused by these features were insufficient to explain the observed Bouguer gravity anomaly values, but the seismic results left open the possibilitues that there may be a considerable thickness of pre-Mesozoic sedimemts north-west of the main monocline or fault. It is postulated that the steep gravity gradient observed may be due to a large fault whose main movement took place in pre-Mesozoic times. Indications are that there is 5000 to 6000 ft of Mesozoic sediments in tha area.

  • Between August and December 1960 a seismic party from the Bureau of Mineral Resources carried out a reconnaissance seismic survey, using reflection and refraction techniques, across the Murray Basin. Traverses were placed at selected localities at Carrathool, Hay, Maude, Balranald, Wentworth, Merbein, Lake Victoria, and Loxton. In general, the results show that the Basin, at least along the line of traverse, consists of essentially undisturbed sediments above a high-velocity basement. The thickness of Basin sediments ranges from about 900 ft at Carrathool to 2200 ft at Lake Victoria and Merbein. Most of the sediments are of Tertiary age, with Mesozoic at Loxton and Wentworth and perhaps at other traverses in the western part of the Basin. The seismic velocity in the sediments has a typical value of about 6000 to 7000 ft/sec, while the velocity in the basement ranges from 15,750 ft/sec (at Hay) up to 20,000 ft/sec (at Lake Victoria). The geological nature of basement is not known, but it is considered that it definitely marks the floor of the Tertiary (or Tertiary - Mesozoic) basin. Refraction velocities alone are of doubtful value in identifying the floor, as it is known that crystalline basement, metamorphosed sediments, or unmetamorphosed sediments such as limestone, may have velocities within this range.

  • Aeromagnetic and gravity surveys were made in the Tambo-Augathella area by Magellan Petroleum Corporation in 1959 and 1960 respectively. A probable fault shown in the magnetic interpretation is almost coincident with a zone of steep gravity gradients which was interpreted as indicative of a fault or of steeply dipping strata. However, the normal gravity interpretation would indicate a deeper cross-section to the south-east of this zone, whereas the magnetic interpretation suggests that the fault is downthrown to the northwest. The present survey was undertaken by the Bureau of Mineral Resources to find out which interpretation was the more probable. A reflection seismic traverse was shot at right angles to the closed gravity 'high' and across the zone of steep gravity gradients. Results show that the closed gravity 'high' is the expression of an anticline and that the zone of stoep gravity gradients is caused by steep dip to the south-east on the flank of the anticline. The gravity interpretation is therefore found to be more representative of actual conditions.

  • A seismic survey, consisting of a main north-south reflection traverse and several short supplementary reflection and refraction traverses, was made in the Gosses Bluff area, of the Amadeus Basin,Northern Territory by a seismic party of the Bureau of Mineral Resources, Geology and Geophysics between March and July 1962. The purpose of the survey was to obtain information on the lli.ssionary Plain Syncline, the Gosses Bluff uplift; the fault at the northenl flank of the Gardiner Range, and the tectonic features relative to the Archaean/sedimentary contact at the northern edge of the Missionary Plain. The seismic reflection method proved to be an excellent exploratory tool in the undisturbed parts of the sedimentary basin. The Missionary Plain Syncline was shovm. to have a maximum thickness of sediments of 33,000 ft, nine miles north of Gosses Bluff. The results indicate that Gosses Bluff is a diapiric structure of the salt dome type, where the Proterozoic Bitter Springs Limestone has provided the necessary mobile material. The Gardiner Range Fault was shown to be overthrust from the south vdth a hade of 15 to 20 degrees. The problem regarding the Archaean/sedimentary contact was not solved.