Australia had a long and illustrious association with 'space science'. The first Australians used the patterns of the stars to guide them to seasonal food sources. Captain Cook arrived here on the way home from a voyage to chart the transit of Venus, with the goal of improving navigational technology. When Governor Phillip founded the first European settlement, he brought with him the astronomer William Dawes. Australia was the fourth nation to build and launch a satellite from its own territory. The 'big dish' at Parkes played an important role in the Apollo missions and the discovery of the first quasar.

Abstract for a Poster for the CO2CRC Symposium 2013: Atmospheric tomography is a CO2 quantification and localisation technique that uses an array of sampling points and a Bayesian inversion method to solve for the location and magnitude of a CO2 leak. Knowledge of a normalized three-dimensional dispersion plume is required in order to accurately model a leak using many meteorological parameters. A previous small scale (~20 m) study using a high precision Fourier Transform Infrared found that the emission rate was determined to within 3% of the actual release rate and the localisation within 1 m of the correct position. The technique was applied during the CO2CRC Otway Stage 2B residual saturation and dissolution test in August-October 2011. A network of eight independent CO2 sensors (Vaisala GMP343 CO2 probes) were positioned at distances ranging from 154 to 473 m from the well. A 3D sonic anemometer within the measurement area collected wind turbulence data. The results of the study indicate that, through careful data processing, measurements from the reasonably inexpensive (but lower accuracy and lower precision) CO2 sensor array can provide useful data for the application of atmospheric tomography. Results have found that the low precision of the sensors over time becomes a problem due to sensor drift. A reference measurement of CO2 helps to resolve this problem and improves the perturbation signal during data processing. Preliminary inversion modeling results will be shown to show the best estimation of locating a CO2 leakage source for the Otway Stage 2B residual saturation and dissolution test. CO2CRC Symposium 2013, Hobart

This folder contains the work related to Climate Future Tasmania project including hazard, risk calculation, standalone tool, management and reports etc.

Geoscience Australia and CO2CRC have constructed a greenhouse gas controlled release facility to simulate surface emissions of CO2 (and other greenhouse gases) from the soil into the atmosphere under controlled conditions. The facility is located at an experimental agricultural station maintained by CSIRO Plant Industry at Ginninderra, Canberra. The design of the facility is modelled on the ZERT controlled release facility in Montana. The facility is equipped with a 2.5 tonne liquid CO2 storage vessel, vaporiser and mass flow controller unit with a capacity for 6 individual metered CO2 gas streams (up to 600 kg/d capacity in total). Injection of CO2 into the soil is via a 120m long slotted HDPE pipe installed horizontally 2m underground. This is equipped with a packer system to partition the well into six CO2 injection chambers. The site is characterised by the presence of deep red and yellow podsolic soils with the subsoil containing mainly kaolinite and subdominant illite. Injection is above the water table. The choice of well orientation based upon the effects of various factors such as topography, wind direction, soil properties and ground water depth will be discussed. An above ground release experiment was conducted from July - October 2010 leading to the development of an atmospheric tomography technique for quantifying and locating CO2 emissions1. An overview of monitoring experiments conducted during the first subsurface release (January-March 2012), including application of the atmospheric tomography technique, soil flux surveys, microbiological surveys, and tracer studies, will be presented. Additional CO2 release experiments are planned for late 2012 and 2013. Poster presented at 11th Annual Conference on Carbon Capture Utilization & Sequestration, April 30 - May 3, 2012, Pittsburgh, Pennsylvania

A short animation of an atmospheric simulation of methane emissions from a coal mine (produced using TAPM) compared to actual methane concentrations detected by the Atmospheric Monitoring Station, Arcturus in Central Queensland. It illustrates the effectiveness of both the detection and simulation techniques in the monitoring of atmospheric methane emissions. The animation shows a moving trace of both the simulated and actual recorded emissions data, along with windspeed and direction indicators. Some data provided by CSIRO Marine and Atmospheric Research.

11-5413 The Probabilistic Volcanic Ash - Hazard Map movie describes how you construct a probabilistic hazard map for volcanic ash, using an example scenario from GA's volcanic ash modelling work in West Java, Indonesia. The target audience is other govt. agencies both national and international, and the general public. The 3.3 minute movie uses 3D Max animations and 2D affects, has narration and production music. The narration will also be done in Bahasa Indonesian, at a later date.

Geoscience Australia and the CO2CRC have constructed a greenhouse gas controlled release facility at an experimental agricultural station maintained by CSIRO Plant Industry at Ginninderra, Canberra. The facility is designed to simulate surface emissions of CO2 from the soil into the atmosphere and is modelled on the ZERT controlled release facility in Montana. Injection of CO2 into the soil is via a 120 m long slotted HDPE pipe installed horizontally 2 m underground. An eddy covariance (EC) system was installed at Ginninderra during the first sub-surface release (March - June 2012). The EC system, which generated 15 minute averages using a 10 Hz sampling frequency, measured net radiation (as a function of upwelling and downwelling, solar and longwave radiation); wind speed and direction in 3 dimensions; CO2 and H2O concentration; and temperature and pressure. The EC system was installed to provide baseline atmospheric measurements and assess methods for quantifying CO2 leakages. The daily CO2 release rate was 100 kg/d. Here we report on the application of the CO2 emissions quantification method developed by Pan et al. (2010) for detecting and quantifying CO2 leakages using EC techniques. The approach seeks to isolate the CO2 leakage signal from the natural variation inherent in flux data, using a time-window splitting scheme, median filtering and scaling techniques. Results from application of the EC method at the Ginninderra site will be presented and modifications to the method and its limitations discussed. Pan, L.; Lewicki, J.L.; Oldenburg C.M.; and Fischer M.L., (2010). Time-window based filtering method for near-surface detection of leakage from geological carbon sequestration sites, Environmental Earth Sciences, 60, pp 359-369. Proceedings of the 2013 International Carbon Dioxide Conference - Beijing China

Geoscience Australia's National Earth Observation Group commissioned this study through the Cooperative Research Centre for Spatial Information. The primary aim of this study was to determine the value of Earth observation from space activities to the Australian economy. The three main objectives of this study were to: 1. estimate the direct and indirect economic value of space based Earth Observation activities to the Australian community in 2008-09 year 2. determine the direct and indirect economic impact of an unplanned denial of all Earth Observation data to the Australian economy in 2008-09 year 3. identify contemplated large-scale government applications of Earth Observation data and estimate their direct and indirect economic value. In subsequent discussions it was agreed that the report would also provide an estimate of the size of the Earth observation from space industry, particularly the small-medium enterprise sector in the 2008-09 financial year. The scope of this report did not include the value of Earth observation from space services for national security or defence.

In July 2010, Geoscience Australia and CSIRO Marine & Atmospheric Research jointly commissioned a new atmospheric composition monitoring station, named Arcturus, in sub-tropical Queensland, Australia. The facility is designed as a proto-type remotely operated `baseline monitoring station' that could be deployed in areas that are likely targets for commercial scale geological storage of carbon dioxide. A key question, given the ecosystem and anthropogenic sources of CO2 in the region, and the absence of a 'clean-wind' sector baseline, is how large would a CO2 leak have to be from a geological storage site before it can be detected above the background CO2 signal? To address this, CO2 leak simulation modelling was performed for 1-year period using the coupled prognostic meteorological and air pollution model TAPM at various locations, emission rates and distances (1-10 km) from the station.

There is increasing recognition that minimising methane emissions from the oil and gas sector is a key step in reducing global greenhouse gas emissions in the near term. Atmospheric monitoring techniques are likely to play an important future role in measuring the extent of existing emissions and verifying emission reductions. They can be very suitable for monitoring gas fields as they are continuous and integrate emissions from a number of potential point and diffuse sources that may vary in time. Geoscience Australia and CSIRO Marine & Atmospheric Research have collected three years of continuous methane and carbon dioxide measurements at their atmospheric composition monitoring station ('Arcturus') in the Bowen Basin, Australia. Methane signals in the Bowen Basin are likely to be influenced by cattle production, landfill, coal production, and conventional and coal seam gas (CSG) production. Australian CSG is typically 'dry' and is characterised by a mixed thermogenic-biogenic methane source with an absence of C3-C6+ alkanes. The range of '13C isotopic signatures of the CSG is similar to methane from landfill gas and cattle emissions. The absence of standard in-situ tracers for CSG fugitive emissions suggests that having a comprehensive baseline will be critical for successful measurement of fugitive emissions using atmospheric techniques. In this paper we report on the sensitivity of atmospheric techniques for the detection of fugitive emissions from a simulated new CSG field against a three year baseline signal. Simulation of emissions was performed for a 1-year period using the coupled prognostic meteorological and air pollution model TAPM at different fugitive emission rates (i.e. estimates of <1% to up to 10% of production lost) and distances (i.e. 10 - 50 km) from the station. Emissions from the simulated CSG field are based on well density, production volumes, and field size typical of CSG fields in Australia. The distributions of the perturbed and baseline signals were evaluated and statistically compared to test for the presence of fugitive methane emissions. In addition, a time series model of the methane baseline was developed in order to generate alternative realizations of the baseline signal. These were used to provide measures of both the likelihood of detecting fugitive emissions at various emission levels and of the false alarm rate. Results of the statistical analysis and an indicative minimum fugitive methane emission rate that can be detected using a single monitoring station are presented. Poster presented at the American Geophysical Union meeting, December 2013, San Francisco